Compressive Strength Of M25 Concrete By Using Quarry Dust

COMPRESSIVE STRENGTH OF CONCRETE USING QUARRY ROCK …

for M25 grade using IS 10262: 2009 for both conventional concrete, Quarry Rock Dust concrete, furnace bed ash concrete. Tests were conducted on the standard 150 mm cubes to study the strength of concrete made out of furnace bed ash and Quarry Rock Dust and the results were compared with the natural sand concrete. It is found

(PDF) Study on Compressive Strength of Quarry Dust as …

Compressive strength of M25 ... acid on the compressive strength of concrete with Quarry Dust as partial replacement of fine aggregate at 0 %, 15 %, 25 % and 35 %. A total of seventy-two (72) 100 ...

Use of Quarry Dust to Replace Sand in Concrete – An ...

Table 5.2 : Compressive strength of M25 concrete in 28 days due to temperature effect Fine aggregate Sand: Quarry dust Compressive strength (MPa) % of reduction in strength compared with control concrete Normal temperature After heated to 100°C 100:0 31.03 24.37 21.47 90:10 31.19 24.50 21.05 80:20 31.52 25.15 18.95 70:30 31.75 25.39 18.18 32.54 25.41 18.12 32.92 26.75 13.80 40:60 31.33 …

Analysis of Concrete Made from Quarry Dust

examples were casted for M25 grade of concrete by supplanting the cement 0%, 5%, 10%, 15% and 20% by quarry dust and tested for workability by slump test, compressive strength, flexure strength and split tensile test at the age of 7, 14, 28 and 50 days. It is seen that the strength results represents that concrete casted with in M25 grade of concrete at 7 days are decreases with replacement of ...

Study on Compressive Strength of Quarry Dust as Fine ...

From the figures it is clear that if the Table 5 .54: Compressive strength of M25 concrete in 28 days due to thermoshockFine aggregate Sand: Quarry dust Compressive strength (MPa) % of reduction in strength compared with control concrete Normal temperature After thermoshock 100:0 31.03 22.22 28.40 90:10 31.19 22.67 26.95 80:20 31.52 23.56 24.08 70:30 31.75 24.00 22.66 60:40 32.54 24.37 …

Research Article Study on Compressive Strength of Quarry ...

Compressive strength of M20, M25, and M30 grade with 0.45 and 0.50 w/c F : CompressivestrengthofM,M ,andMgradewith w/c . and . . grade also was observed with varying age of concrete by replacement level up to %. (c) e compressive strength results of quarry dust concrete (cubes) were obtained in the third series, where

(PDF) Study on Performance of Quarry Dust as Fine ...

Method of curing by ponding was adopted and the compressive strength of quarry-dust-iron-filings-blended concrete with varying materials proportions of 12.5%, 25%, 37.5% and 50% at 28days of ...

PARTIAL REPLACEMENT OF SAND BY QUARRY DUST IN …

compressive strength of M20 and M25 grades of concrete on partial replacement of sand by Quarry dust by 20%, 30%, 40% and 50%. The compressive strength of concrete cubes are obtained after 7 and 28 days of curing. This experimental study shows that the concrete made with quarry dust might not be as workable as normal concrete but it gives higher strength than the conventional concrete. …

Effect of Quarry Dust on High Performance Concrete

suitability of using quarry dust in concrete and to compare its properties with that of the conventional concrete. Hence a ... cement content, workability, compressive strength and cost of concrete made with Quarry Rock Dust. The mix design proposed shows the possibilities of ensuring the workability by wise combination of rock dust and sand, use of super plasticizer and optimum water content ...

COMPRESSIVE STRENGTH OF CONCRETE USING QUARRY ROCK DUST …

for M25 grade using IS 10262: 2009 for both conventional concrete, Quarry Rock Dust concrete, furnace bed ash concrete. Tests were conducted on the standard 150 mm cubes to study the strength of concrete made out of furnace bed ash and Quarry Rock Dust and the results were compared with the natural sand concrete. It is found

Research Article Study on Compressive Strength of Quarry ...

Compressive strength of M20, M25, and M30 grade with 0.45 and 0.50 w/c F : CompressivestrengthofM,M ,andMgradewith w/c . and . . grade also was observed with varying age of concrete by replacement level up to %. (c) e compressive strength results of quarry dust concrete (cubes) were obtained in the third series, where

PARTIAL REPLACEMENT OF SAND BY QUARRY DUST IN …

compressive strength of M20 and M25 grades of concrete on partial replacement of sand by Quarry dust by 20%, 30%, 40% and 50%. The compressive strength of concrete cubes are obtained after 7 and 28 days of curing. This experimental study shows that the concrete made with quarry dust might not be as workable as normal concrete but it gives higher strength than the conventional concrete. …

Compressive strength of concrete made with quarry dust ...

Application of quarry dust in concrete construction Flat. Mix design has been developed for three grades using design an approach IS, ACI, USBR, RNNo4 and BRITISH for both conventional concrete and quarry dust concrete Tests were conducted on cubes and beams to study the strength of concrete made of Quarry Rock Dust and the results were compared with the Natural Sand Concrete

(PDF) BEHAVIOUR OF CONCRETE ON THE USE OF …

TENSILE STRENGTH OF CONCRETE ( MPA) 10:90 15.85 19.67 18.66 23.25 Fine aggregate 28 days Sand: Quarry dust M20 M25 0:100 14.86 18.66 17.78 22.66 100:0 2.80 3.17 From the Figures 1 and 2, it is observed that the 7 days and 90:10 2.90 3.29 28 days compressive strength of concrete reached maximum value at 50% replacement. 80:20 3.10 3.35 70:30 3.25 3.44 60:40 3.30 3.58 50:50 3.40 …

Behaviour Of Concrete On The Use Of Quarry Dust To …

USE OF QUARRY DUST TO REPLACE SAND IN CONCRETE –AN EXPERIMENTAL STUDY G.Balamurugan et al. (2013) investigated, this experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete …

[PDF] Use of Quarry Dust to Replace Sand in Concrete - …

This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also the temperature effect on concrete cubes at 100 o …

[PDF] Study on Compressive Strength of Quarry Dust as …

The concept of replacement of natural fine aggregate by quarry dust which is highlighted in the study could boost the consumption of quarry dust generated from quarries. By replacement of quarry dust, the requirement of land fill area can be reduced and can also solve the problem of natural sand scarcity. The availability of sand at low cost as a fine aggregate in concrete is not suitable and ...

IMPACT OF QUARRY DUST & DOLOMITE POWDER ON COMPRESSIVE …

KEY WORDS: Dolomite, Quarry dust, Compressive strength, Partial Replacement INTRODUCTION Concrete is a composite material that consists of binding medium, such as mixture of Portland cement and water, within which are embedded particles or fragments of aggregate, usually a combination of fine and coarse aggregate. Concrete is by far the most versatile and most widely used construction …

Introduction to Quarry-Dust as Partial Replacement ...

Experimental Study has shown the effect on Compressive strength of concrete by replacing cement with 10%,20% and 30% of quarry dust by S. Nazma and S. Madhavi [1]. They have concluded the linear increase in compressive strength by replacing quarry dust upto 10 to 20% and observed decreasement if replaced more than 20 to 30% and Also optimization of cement content can be achieved by using ...

COMPRESSIVE STRENGTH OF CONCRETE USING QUARRY ROCK DUST …

for M25 grade using IS 10262: 2009 for both conventional concrete, Quarry Rock Dust concrete, furnace bed ash concrete. Tests were conducted on the standard 150 mm cubes to study the strength of concrete made out of furnace bed ash and Quarry Rock Dust and the results were compared with the natural sand concrete. It is found

PARTIAL REPLACEMENT OF SAND BY QUARRY DUST IN …

compressive strength of M20 and M25 grades of concrete on partial replacement of sand by Quarry dust by 20%, 30%, 40% and 50%. The compressive strength of concrete cubes are obtained after 7 and 28 days of curing. This experimental study shows that the concrete made with quarry dust might not be as workable as normal concrete but it gives higher strength than the conventional concrete. …

[PDF] Use of Quarry Dust to Replace Sand in Concrete - …

This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also the temperature effect on concrete cubes at 100 o …

Behaviour Of Concrete On The Use Of Quarry Dust To …

USE OF QUARRY DUST TO REPLACE SAND IN CONCRETE –AN EXPERIMENTAL STUDY G.Balamurugan et al. (2013) investigated, this experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete …

Partial Replacement of Sand by Quarry Dust in Concrete

Quarry dust can be defined as residue, tailing or proportions of cement concrete + quarry dust (M 20, AND M25). other non-voluble waste material after the extraction and The experimental results showed that the addition of quarry dust processing of rocks to form fine particles less than 4.75mm. as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties. Test on ...

Behaviour of Concrete on Replacement of Sand with …

Mix design has been developed for M25 and M40 grades using design approach IS for both conventional concrete and quarry dust concrete. Tests were conducted on cubes and beams to study the strength of concrete made of Quarry Rock Dust and the results were compared with the Natural Sand Concrete. It is found that the compressive and flexural strength of concrete made of Quarry Rock Dust are ...

IMPACT OF QUARRY DUST & DOLOMITE POWDER ON COMPRESSIVE …

KEY WORDS: Dolomite, Quarry dust, Compressive strength, Partial Replacement INTRODUCTION Concrete is a composite material that consists of binding medium, such as mixture of Portland cement and water, within which are embedded particles or fragments of aggregate, usually a combination of fine and coarse aggregate. Concrete is by far the most versatile and most widely used construction …

Introduction to Quarry-Dust as Partial Replacement ...

Experimental Study has shown the effect on Compressive strength of concrete by replacing cement with 10%,20% and 30% of quarry dust by S. Nazma and S. Madhavi [1]. They have concluded the linear increase in compressive strength by replacing quarry dust upto 10 to 20% and observed decreasement if replaced more than 20 to 30% and Also optimization of cement content can be achieved by using ...

m25 concrete with stone dust - Help4Help

The set of series are, M20 M25 grade of concrete with 10, 20, 30, 40, 50 and 60 percentage replacement of quarry dust tested for 7 days, and 28 days is studied and the results are presented. 50% replacement of sand by quarry dust gives higher compressive strength than natural sand concrete. Key Words: Concrete, quarry dust, river sand, Get Price

(PDF) Comparative study on strength and economy of ...

Green concrete is cheap to produce since waste To use stone quarry dust as a complete replacement of fine products or recycled materials are used as a partial substitute aggregate in concrete. for cement, charges for the disposal of waste are avoided, To conduct experimental analysis for compressive strength energy consumption while production is quite lower, and of M20 and M25 concrete grades ...